M and MSM Series
cancel
Showing results for 
Search instead for 
Did you mean: 

3CRWER100-75 fail after firmware upgrade to 1.3.06

 
Highlighted
Emiel
Occasional Visitor

3CRWER100-75 fail after firmware upgrade to 1.3.06

I upgraded my 3CRWER100-75 wireless router from 1.3 to 1.3.06 with the firmware upgrade found on: http://csoweb4.3com.com/wireless_update/default.cfm?file=69



This caused the wireless router to stop functioning as expected:





  • My computer does not receive a IP-adres automatically

  • The webinterface of the machine is not available, also not with a fixed IP on my computer

  • The wlan light does not lighten up.

  • Any reset action does not seem to work.





Oddly, the four LAN connectors still function as a hub/switch.



The used firmware file was 3CRWER100or200-75_v1.3.06_SH.fim as found in the upgrade file.



I'd like to refer to http://forums.3com.com/viewmessages.cfm?forum=22&Topic=331 where the same problem seems to have occured.



How can I have my router restored to its fully working state?



2 REPLIES 2
Highlighted
Emiel
Occasional Visitor

Re: 3CRWER100-75 fail after firmware upgrade to 1.3.06

I upgraded my 3CRWER100-75 wireless router from 1.3 to 1.3.06 with the firmware upgrade found on: http://csoweb4.3com.com/wireless_update/default.cfm?file=69



This caused the wireless router to stop functioning as expected:





  • My computer does not receive a IP-adres automatically

  • The webinterface of the machine is not available, also not with a fixed IP on my computer

  • The wlan light does not lighten up.

  • Any reset action does not seem to work.





Oddly, the four LAN connectors still function as a hub/switch.



The used firmware file was 3CRWER100or200-75_v1.3.06_SH.fim as found in the upgrade file.



I'd like to refer to http://forums.3com.com/viewmessages.cfm?forum=22&Topic=331 where the same problem seems to have occured.



How can I have my router restored to its fully working state?



Highlighted
Jonimus
Occasional Visitor

Re: 3CRWER100-75 fail after firmware upgrade to 1.3.06

I an having the same issue.



I have tried all the recommended methods of resetting it to the default settings as the upgrade release notes suggested resetting the settings after a firmware upgrade but no matter what I do it does not behave any differently. I have also tried setting up a satic IP on my computer and access the WebUI that way with no luck, nor does it respond to ping.



If there is any other information I could provide to assist with finding a solution I would be happy to oblige.