M and MSM Series
cancel
Showing results for 
Search instead for 
Did you mean: 

Connecting to a controller (MSM710) from annother subnett

 
SOLVED
Go to solution
Highlighted
Rene van Veen_1
Occasional Contributor

Connecting to a controller (MSM710) from annother subnett

Hi

I'm trying to find out why I'not able to connect to the management web konsol when I'm not on the same subnett.

I got about 10 kontrollers going with different customers and want to beable to control them directly through the management interface after logging on to the remote nett through any kind of a VPN connection.

It just times out. I've been looking in docs and boards but cannot find anything.

What 'm  I doing wrong?

Rene

3 REPLIES 3
Highlighted
Fredrik Lönnman
Honored Contributor

Re: Connecting to a controller (MSM710) from annother subnett

If you have a route to your management station it shouldnt be a problem. Also under the management settings you can specify the subnets that are allowed to manage the controller, but default it will permit any src.

---
CCIE Service Provider
MASE Network Infrastructure [2011]
H3CSE
CCNP R&S

Highlighted
Rene van Veen_1
Occasional Contributor

Re: Connecting to a controller (MSM710) from annother subnett

Ok. To keep it simple. I'm sitting at home and the controller a msm710 is at the office. I got an IPSEC route/tunnel between the FW at home and the office. There is a routing rule on both ends an there is explicit rule to allow everything both way's in both end's. Stil when I try to contact the controller from my subnett it just time's out.

Any more suggestions plz?

Rene

Highlighted
Rene van Veen_1
Occasional Contributor
Solution

Re: Connecting to a controller (MSM710) from annother subnett

Hi again.

It's yhe same as with the AP waiting. I neded a routa satt up on the MSM7xx.

I think this can be a some work.

Rene