Html login page bypassed

[Ali_Moghrabi]

Hello,

I'm trying to set up a guest/corporate networks using an msm760 controller and 10 aps.

i haven't got it up and running yet because i ran into certain issues.

When i connect to the guest or the corporate network, the user gets access to the internet without the login page being shown, even though i check it on the VSC config page.

the guest is using a local html login profile

and corporate is using active directory. 

both are getting bypassed.

any help would be appreciated.

Thank you.

[JesseR]

Do you have the client data tunnel enabled on the guest VSC?

JR

Need help with MSM deployments?

http://h30499.www3.hp.com/t5/MSM-Series/MSM-Deployment-Scenario-How-To-Guide/td-p/5717081

[Ali_Moghrabi]

Hello, 

Thank you for the reply

No i have it disabled. Should i enable it?

ill take a look a that post. thx

[Ali_Moghrabi]

ok i found the problem but not the solution.

i set up the dhcp server on the controller in a way so tht the controller is the default gw and dns server. so it worked and the html login page appeared. but the next time i checked the settings, they had changed. for some reason the pc is using the external dhcp server used for the rest of the network and not the one i set up on the controller. 

so bcz of that the user has access to the internet without going through the login page.

in conclusion: the external dhcp server is overriding the config of the local controller based dhcp server

any ideas?

[Ali_Moghrabi]

bump

[Ali_Moghrabi]

now the login page appears, but after a successful login, the users don't have internet access..

anyone has any idea?

[gglater]

---

@Ali_Moghrabi wrote:

now the login page appears, but after a successful login, the users don't have internet access..

anyone has any idea?

---

What is the support case number for this issue?  I'll check on the status...