MSM-320 R Wireless to wireless?

[Adam E]

I have an MSM-320 R (Ruggedized) AP with 2 antennas. I am wondering if I can have it connect wirelessly to another AP (picture attached).

If it matters, the other AP is a MAP-320 R

Thanks in advance!

P.S. This thread has been moved from Communications, Wireless (Legacy ITRC forum) to MSM Series. - Hp Forum Moderator

[cenk sasmaztin]

Map 320 R namely MSM310 R

Yes it is possible

[Adam E]

Okay, I'm looking at the manual on page 7-2.. it says to set up a static local mesh, and put the 'others' mac address in for remote mac address. I have done that... they still are not connecting?

[cenk sasmaztin · Accepted solution]

Ok..
don't use static mesh.
You can connect dynamic mesh very succesfull and very easy

One ap master and another ap slave mode
Mesh id must be same two access point
And
Radio channel must be same
For example channel 1

[cenk sasmaztin]

And radio mode must be localmesh and accesspoint

[Adam E]

Okay, I have done this.

I can wirelessly connect to either AP, and gain access to both AP's (can log in). But can't access other devices connected to the other AP (but can access devices on the same AP).

Any ideas?

(policy managers and wireless security filters are turned off).

Thanks!