M and MSM Series
cancel
Showing results for 
Search instead for 
Did you mean: 

MSM 760 Access controller - no IP comms after ugprade

 
Highlighted
Kev_Burgess
Occasional Contributor

MSM 760 Access controller - no IP comms after ugprade

760 Access controller has no ARP, cannot ping it, tried factory addressing, tried "linux factory" command on console cable. Cannot ping, web browse etc etc. ANy suggestions would help. Gone from

5.7.5.0 (Maintenance) -> 6.2.1.1

1 REPLY 1
Highlighted
johnk3r
Respected Contributor

Re: MSM 760 Access controller - no IP comms after ugprade

Hmmm ...

I do not know if it was the cause of this problem, but the build date of the V5.7.5.0 version is 04-Dec-2014 and the V6.2.1.1 version 06-Nov-2014.

I believe there was a downgrade configuration and something has been lost. You can configure IP address for Console/CLI and after test connectivity?

**************************************
ATP FLEXNETWORK V3 | ACSA