M and MSM Series
cancel
Showing results for 
Search instead for 
Did you mean: 

MSM760 Guest HTML Login Page not being presented

 
Highlighted
Colin Benson
Advisor

MSM760 Guest HTML Login Page not being presented

I have a Guest VSC configured as follows:-

 

- teamed controllers so DHCP relay setup for subnet 192.168.90.x - DNS & GW address pointing to TEAM virtual IP address 192.168.4.223

- Guest VLAN created (999) - Egress VLAN set on VSC to push traffic through the internet port 192.168.99.2

- WPA2/PSK created for security

- user can connect to the Guest network and gets an IP address on the 192.168.90.x showing the DNS & GW of the team IP address but does not get the HTML login page..

 

any suggestions as to where I have gone wrong? 

 

3 REPLIES 3
Highlighted
Fredrik Lönnman
Honored Contributor

Re: MSM760 Guest HTML Login Page not being presented

Im pretty sure you'll have to use a separate IP in the VSCs per controller for the guest VSCs, the TEAM vIP is only to be used for management purposes to hit the active MSM (at least that's what I was told ~year ago)

---
CCIE Service Provider
MASE Network Infrastructure [2011]
H3CSE
CCNP R&S

Highlighted
Colin Benson
Advisor

Re: MSM760 Guest HTML Login Page not being presented

so if I have this right within the DHCP scope for that Guest VSC (192.168.90.x) I should set the GW & DNS to point to the IP specified against the subnet ID within the DHCP section of the VSC (in this case 192.168.90.1) - correct?

Highlighted
Fredrik Lönnman
Honored Contributor

Re: MSM760 Guest HTML Login Page not being presented


@Colin Benson wrote:

so if I have this right within the DHCP scope for that Guest VSC (192.168.90.x) I should set the GW & DNS to point to the IP specified against the subnet ID within the DHCP section of the VSC (in this case 192.168.90.1) - correct?


Yes.

---
CCIE Service Provider
MASE Network Infrastructure [2011]
H3CSE
CCNP R&S