HPE Community
M and MSM Series
1752795 Members
6363 Online
108789 Solutions
New Discussion

MSM760 - How do you remove a certain bridge entry from the controller

 
StevePogue
Occasional Contributor

‎04-05-2012 10:18 AM - last edited on ‎12-01-2013 06:19 AM by

‎04-05-2012 10:18 AM - last edited on ‎12-01-2013 06:19 AM by

MSM760 - How do you remove a certain bridge entry from the controller

Our Guest users cannot reach a certain internet address 76.75.13.3

 

When the following command is entered on the MSM760 controller web admin interface the above address shows up with a bridge entry:

 

command: show routes table 0

 

result:

 

76.75.13.3 dev br0 table 100 scope link

 

I believe that this entry is causing the routing problem and would like assistance on how to remove it.

 

Computers plugged directly into the Wan network have no problem reaching 76.75.13.3

That is an external address for a mail server not located within our networks.  About 10 hops away.

 

P.S. This thread has been moved from Communications, Wireless (Legacy ITRC forum) to MSM Series. -HP Forum Moderator

 

 

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.