M and MSM Series
cancel
Showing results for 
Search instead for 
Did you mean: 

Need the xxx.cim.startup for HP 560

 
Highlighted
podge3
Occasional Visitor

Need the xxx.cim.startup for HP 560

Anyone know where/how I can get the xxx.cim.startup for the HP 560?

 

Thanks.

17 REPLIES 17
Highlighted
RamKrish
Valued Contributor

Re: Need the xxx.cim.startup for HP 560

I have sent you a private message with a link to download the startup file.

 

Ram

Regards
Ram
Highlighted
podge3
Occasional Visitor

Re: Need the xxx.cim.startup for HP 560

Thanks!

Highlighted
Kristian Gyllström
Occasional Visitor

Re: Need the xxx.cim.startup for HP 560

Me too have this problem on three new HP 560 Access Points that we need to convert to stand-alone. Please send us the link. Thank you!

Highlighted
ProfessorH
Occasional Visitor

Re: Need the xxx.cim.startup for HP 560

Please send me this link as well. We just got a new 560 and it has the boot image that has only provisioning mode and I need to get 6.6.0 on there.

Highlighted
RamKrish
Valued Contributor

Re: Need the xxx.cim.startup for HP 560

Hi

 

Are you trying to use the HP560 into controlled mode or autonomous mode?

 

If the intention is to use in controlled mode, then all you need to do is to simply plug the AP into the controlller environment.  It should be able to get the code from the controller. 

 

Once it gets the code from the controller, you may choose to convert the AP into autonomos mode.

 

Regards

Ram

Regards
Ram
Highlighted
hny1
Occasional Visitor

Re: Need the xxx.cim.startup for HP 560

Dear concerned ,

i also want to use an AP in MSM autonomous mode and i do not have an MSM Controller. 

i need to download xxx.cim.startup file. 

please help

 

regard

Haroon Naseem

Highlighted
RamKrish
Valued Contributor

Re: Need the xxx.cim.startup for HP 560

I just figured it out we have the .startup.cim file available on the software download page (need to use your HP passport login to get to the download section)

 

Download page for HP560:  Under HP My Networking --> My Software --> look for 560 search, that should take you to the download page).

 

URL for Download page:

https://h10145.www1.hpe.com/downloads/DownloadSoftware.aspx?SoftwareReleaseUId=11635&ProductNumber=J9846A&lang=&cc=&prodSeriesId=&OrderNumber=&PurchaseDate=

 

Upgrade Procedure:

Refer to section (Load Method 2: Using TFTP)

 

http://h20565.www2.hpe.com/hpsc/doc/public/display?sp4ts.oid=6898336&docId=emr_na-c04514138&docLocale=en_US

 

Hope this helps.

 

 

 

Regards
Ram
Highlighted
Tomasz_J
Occasional Visitor

Re: Need the xxx.cim.startup for HP 560

I also need this file  - could somene post link here?

Rgds

Highlighted
y7y_k7
Occasional Visitor

Re: Need the xxx.cim.startup for HP 560

Hello,

could you please send me the link i have the same problem.

B.R