M and MSM Series
cancel
Showing results for 
Search instead for 
Did you mean: 

Problem with MSM320 Access Point Configuration

 
Occasional Visitor

Problem with MSM320 Access Point Configuration

Hi,
We are Installing new Wireless setup.We using Hp MSM320 Access Point in Stand-alone Autonomous Mode.We have only one VLAN 1 IP Subnet 192.168.0.0/24.We Configure AP bridge port ip 192.168.0.180 & created SSID.
Now the problem is this i can see SSID in our wireless network then i given sataic IP address to my PC in same subnet & try to connect it's connecting successfully but i unable to ping AP ip & unable to browse internet.

 

P.S. This thread has been moved from Communications, Wireless (Legacy ITRC forum) to MSM Series. -HP Forum Moderator

2 REPLIES 2
Highlighted
Frequent Advisor

Re: Problem with MSM320 Access Point Configuration

what i would do is check your ip routes and make sure you put in your default gateway.
Highlighted
Occasional Visitor

Re: Problem with MSM320 Access Point Configuration

i have only 1 vlan through LAN network everything is working fine only having problem with wireless & default gateway is already configured.