Problem with MSM460 and MSM760 after update firmware

[johnk3r]

Hello everyone!

I'm doing the deploy APs using the provisioning method. The Controller and the antennas are on different networks (networks connected by IPSEC). I am setting up provisioning in AP.

Communication / synchronize functioned normally in using the firmware V6.2.1.1. After updated the Controller for V6.4.0.0 firmware and the problem started happening.

At this moment I have 2 MSM460 being managed by the Controller. These two are on the same network of the Controller. I have another AP that was connected to the controller with the way provision, that stopped working after the upgrade.

Reseted the AP three times, however when it connects to the controller the problem occurs and it is inaccessible both the Controller and locally, leaving only to reset default again.

Below the error found in the Controller logs:

Nov 27 17:21:14.337    err    pbserver: Failed to commit transaction (ID=<191>, error=<Invalid IP address.>).
Nov 27 17:21:14.336    err    confighandler: =provisioning=><Invalid IP address.>

[johnk3r · Accepted solution]

Problem solved after disabling Provision in global mode.