M and MSM Series
cancel
Showing results for 
Search instead for 
Did you mean: 

unable to access the MSM415 by hyper terminal

 
Highlighted

unable to access the MSM415 by hyper terminal

I am trying access the MSM415 through hyper terminal with no success.
I used the correct hyperterminal settings as follows:

 

 Bits per second: 115200

 Data bits: 8
 Parity: None
 Stop bits: 1
 Flow control: None

 

But am still cannot access the sensor.
Kindly advise...

1 REPLY 1
Highlighted
Richard Litchfield
Respected Contributor

Re: unable to access the MSM415 by hyper terminal

The settings are correct (the MSM415 default).

 

Make sure you are connected via a genuine serial port. The USB adapters very rarely work at that speed.

 

If you have an IP address for it (check the DHCP server assignments), you can ssh into it instead. Try a hard reset too (paperclip in the reset hole for 3 LED flashes) in case the config is stopping a DHCP assignment.