Brocade Firmware Install Looping

[mburse]

Hello,

Do you know if there is a way to stop/kill/end a firmwaredownload process? Its been running for 5 hours now!

A reboot/reset/reseat does not stop it. It’s a 4/12 Blade Brocade SAN switch in a C7000 chassis running new firmware 2.13. Running 5.3.0a on FOS Primary 4/12 switch

Screen message is just “FOS Secondary Partition updating this will take up to 10 minutes” Then is finishes successfully and starts again….Looping see below

15]: Fri Mar 7 11:25:36 2008

Firmware commit operation has started to restore the secondary partition.

: Fri Mar 7 11:40:16 2008

Firmware commit operation has started to restore the secondary partition.

: Fri Mar 7 11:56:05 2008

Firmware commit operation has started to restore the secondary partition.

: Fri Mar 7 12:42:59 2008

The firmware commit operation has started. This may take up to 10 minutes.

: Fri Mar 7 12:43:13 2008

Firmwarerestore is entered. System will reboot and a firmware commit operation w

ill start upon boot up.

: Fri Mar 7 12:49:18 2008

Firmware commit operation has started to restore the secondary partition.