MSA Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

CLI for MSA 500 G2

 
SJ1436
Frequent Advisor

CLI for MSA 500 G2

Hi,

I need to access the CLI for msa500G2 to check what raid level is configured on it, i used the same configuration of the hHyperTerminal connecton of the msa1000 but it did not work.
any body has an idea on how to access it ?

Thanks in advance,
SJ
3 REPLIES 3
YAQUB_1
Respected Contributor

Re: CLI for MSA 500 G2

Hi,

U follow the below process:-

1. U connect serial cable (Special Serial Cable one end DB9 pin and another end RJ45 port) laptop/PC MSA controller front I/O port

2. Set up a Hyper Terminal emulator from the host computer using the following settings:
Bits per second: 19200
Data bits: 8
Parity: none
Stop bits: 1
Flow control: none

3. After opening the session, press Enter several times to display the CLI command prompt.

4. At the CLI prompt, enter the following command: show tech_support

This command outputs U have find out all configuration info.

Assign points, if Ur requirement is match.

Thanks--Yaqub
HP Support!!!
SJ1436
Frequent Advisor

Re: CLI for MSA 500 G2

Hi Yaqub,

Thanks for your reply.
the procedure that you sent only applies for MSA 1000/1500. it doesnt work on MSA 500.

Best Regards,
SJ
Khurram Shahzad
Regular Advisor

Re: CLI for MSA 500 G2

Hi SJ,

Than how can we access MSA500 Host port.

Regards,

Khurram Shahzad