Configuring P2000 G3 using the CLI

[Igor V Abzalov]

Hi. Same problem - i can't access to P2000 through LAN or USB cable. HyperTerminal just show blinking cursor. If i set 10.0.0.5/24 IP on my PC in same VLAN with ports of P2000 - i can't ping 10.0.0.2 or 10.0.0.3.
DHCP is running in this VLAN, but i don't see any address leases from P2000.

[Igor V Abzalov]

Well. Today i can access my Controller B on P2000 by USB COM3 port from Windows Server 2003 with USB cable. I think it is after rebooting server. Some problem still exist - if i reconnect to Controller A (upper slot) - i do not see COM3 port on server and i see Unknown device in USB devices tree. May it be hardware problem?

[saleta]

Hi Everyone,


Is it any chance that anyone has a driver Gadget Serial v 2.4 P2000 ? I can't get to P2000 through CLI....


Best Regards,

[LanioAmaral]

The USB driver on COM3 port is properly installed with 9600 bit speed per second.
But, in addition, HP support said I should connect with Putty.
1- Open the Putty.
2 - Click on loggin> check the option: "All session output".
3- Click the "Brownse" button and choose where you want to save the logs.
4- Go back to "Session".
To connect.
On the black screen, enter login, press ENTER.
Enter the password and ENTER.