Configuring network on MSA2050

[JPECO]

Hi

I am unable to configure network settings via SMU on MSA2050.

I want to apply a static IP but it always comes back to factory settings (dhcp, 10.0.0.2).

I have tried on different browsers. Same result.

It goes well on CLI connection.

Any known issue ?

Thanks for your reply.

Regards.

[slavtechbuer]

Hi there, 

So you cannot estabilish connection on MSA, can you try to rest controllers to factory defaults: restore defaults factory command on CLI. 

Then once when you will put set network-parameters ip make sure that you will use IP from your subnet., Also ypu can check protocols: show protocols, http must be enabled.

Kind Regards

Slav