MSA Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

Doesn't start SAN Switch HP StorageWorks 8/

 
inetimon
Occasional Contributor

Doesn't start SAN Switch HP StorageWorks 8/

Hello.

Forgive, I use the translator.

There is a problem with HP StorageWorks 8/8 SAN Switch.

At start shuts up on reading of information from a flash card.

How to be that it is possible to make???

 

U-Boot 1.1.3 (Aug 31 2010 - 19:43:19)

CPU:   AMCC PowerPC 440EPx Rev. A at 660 MHz (PLB=132, OPB=66, EBC=33 MHz)
       No Security/Kasumi support
       I2C boot EEPROM enabled
       Bootstrap Option G - Boot ROM Location I2C (Addr 0x54)
       Internal PCI arbiter enabled, PCI async ext clock used
       32 kB I-Cache 32 kB D-Cache
Board: Tomahawk
I2C:   ready
DRAM:  Initializing DDRSDRAM
DDR Init: speed = 132000002
DQS calibration - Window detected:
max_passing_cases = 55
wr_dqs_shift      = 93
dll_dqs_delay_X   = 31
dll_dqs_delay_X window = 4 - 58
DDR0_09=0x00011d5d
DDR0_22=0x00267d0b
DDR0_17=0x1f005d00
DDR0_18=0x1f1f1f1f
DDR0_19=0x1f1f1f1f
ECC Enabling   DONE
512 MB
POST RAM test disabled.
Now running in RAM - U-Boot at: 1fb31000
trap_init : 0x0
system inventory subsystem initialized
FLASH: Tomahawk CFI Flash Driver Initialized
 4 MB

 

1 REPLY 1
Johan Guldmyr
Honored Contributor

Re: Doesn't start SAN Switch HP StorageWorks 8/

Hi, 

 

it should be possible to via commands in the serial console change which flash (at least partition, maybe disk too) that the switch boots on. I do not have instructions but they are available on brocade's forum.

 

8/8 is HP's name for Brocade's "Brocade 300"