MSA Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

EVA 4400 Controller halted after replacement

 
isomat
Occasional Visitor

EVA 4400 Controller halted after replacement

I have an EVA 4400 with dual controllers. One of the controller went offline and after I replaced it because it was bad, I can't get it to reconnect. C.V. will not even recognize it and the Controller Module interface says it is halted when I log in. How do I re-enable this controller

2 REPLIES 2
Torsten.
Acclaimed Contributor

Re: EVA 4400 Controller halted after replacement

When you replaced the controller, did you place the memory dimms into the new part?

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Yaboto
Super Advisor

Re: EVA 4400 Controller halted after replacement

 

Remove the Memory module from the old one and fix it into the new one. Without it the new controller would not boot. The first time I replaced an EVA controller, I had the same experience. Now the first thing I do is to remove the PROM module from the old controller before any replacement.

 

Best regards,

Yaboto