HPE Community
MSA Storage
1751847 Members
5277 Online
108782 Solutions
New Discussion

EVA5000 Loop Pair Failure

 
CA1012336
Occasional Contributor

‎09-18-2006 12:02 AM

‎09-18-2006 12:02 AM

EVA5000 Loop Pair Failure

I received a notification from Command Veiw stating that a loop pair failure occurred. If I look at the EVA5000 itself there are no flasking red lights, no errors on the display, nothing to indicate a failure. Yet if I look in Command View and I look at the "Device Ports" tab under either controller it shows the ooperationals state as "Failed". If I try to enable it, it does nothing. Any ideas how to correct this?
Of course I don't lokk busy, I did it right the first time
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.