MSA Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

Ethernet Management Port Set to 10mb, need 100 mb!

 
Jay R. Perry III
Occasional Visitor

Ethernet Management Port Set to 10mb, need 100 mb!

Hopefully this is a simple fix but I can't figure it out..

The rear ethernet management port is set to 10mb and I need 100mb.. Where do I find this setting to change? We have two 4/16 SANs here in the office and one runs at 100mb, and one at 10mb. I've exchanged cables between the two and it remains 10mb so it's not the cable being used.

Thanks,

Jay
1 REPLY 1

Re: Ethernet Management Port Set to 10mb, need 100 mb!

Not sure about the Webtools GUI interface, but the CLI (telnet) command is "ifmodeset eth0".
You may want to start with setting everything on (all speeds, auto-negotiate), just to make sure there isn't anything set anywhere else. Then you can lock it to the desired speed.

Note: While I am an HPE Employee, all of my comments (whether noted or not), are my own and are not any official representation of the company

Accept or Kudo