FW synchronization algorithm when replacing P2000 MSA G3 controller

[sfuji]

G4/G5世代のMSAのSMUリファレンスガイドには保守部品のコントローラー交換を実施した場合、元のコントローラーから交換部品へFWが同期されるとの記載があるが、P2000 MSA G3には同様の記載が見つかりませんでした。

G3のMSAも同様のFW同期アルゴリズムが動作するのか確認したい。

Google Translated

The SMU reference guide for the G4 / G5 generation MSA states that if a maintenance part controller is replaced, the FW will be synchronized from the original controller to the replacement part. Could not be located. I want to check if the same FW synchronization algorithm works for G3 MSA.

[Cali]

Hi,

go to the CLI and enter:

show advanced-settings

Look for

Partner Firmware Upgrade

The command is:

set advanced-settings partner-firmware-upgrade enabled|disabled|on|off

Cali

[Torsten.]

For the P2000 (MSA2000 G3) the controller with the newer firmware clones to the controller with the older firmware.

This is different to G4 and G5 (see above).