- Community Home
- >
- Storage
- >
- Entry Storage Systems
- >
- MSA Storage
- >
- Failovermode with one Switch and two HSG80
MSA Storage
1753752
Members
5068
Online
108799
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-14-2004 08:12 AM
06-14-2004 08:12 AM
Failovermode with one Switch and two HSG80
Hi,
I have a RA8000/ESA12000 with two HSG80 controllers, but only one switch.
As far as I know, I only can use this configuration as transparent failover. Is it possible to use the second controller as a kind of load balancing as long there is no failover in one of the controller ?
regards
Volker
I have a RA8000/ESA12000 with two HSG80 controllers, but only one switch.
As far as I know, I only can use this configuration as transparent failover. Is it possible to use the second controller as a kind of load balancing as long there is no failover in one of the controller ?
regards
Volker
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-14-2004 09:09 PM
06-14-2004 09:09 PM
Re: Failovermode with one Switch and two HSG80
Volker,
as I wrote here:
http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=614374
there is no problem using two HSG80 controller modules in multibus failover-mode on one switch.
You can do 'load balancing' on the unit level by equally distributing you units over both controllers. True 'load balancing' only works between both host ports of a single controller.
as I wrote here:
http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=614374
there is no problem using two HSG80 controller modules in multibus failover-mode on one switch.
You can do 'load balancing' on the unit level by equally distributing you units over both controllers. True 'load balancing' only works between both host ports of a single controller.
.
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP