HP P2000 G3 MSA FC. Vdisk verification failed. Scrub failed on vdisk

[pub10]

After a power failure got three problems:

1)
Vdisk verification failed. Command failed. (error code: 1) 1 error(s) were found. (vdisk: vDisk01, SN: 00c0ff112a45000014fd5c4d00000000)
2) Scrub failed on vdisk: vDisk01 SN: 00c0ff112a45000014fd5c4d00000000 Number of parity mismatches found: 1. If a disk fails data may be at risk. Action required: See the Event Descriptions Reference Guide for the recovery procedure.

3) network port on one of the controller does not work

How can I fix these errors?

P.S. This thread has been moved from HP Support Center (Website) Feedback & Suggestions to Disk Arrays. - Hp Forum Moderator

[Zsal]

I see two issues here: Vdisk and Network port issue. You need to use the verify-fix utility to fix the vdisk issue.

CAUTION: The logs need to be thoroughly checked to rule out any hardware defect on any of the disks. Running verify-fix without doing this check could lead to massive data loss.

It is recommended to contact HP support to perform the above procedure.

Hope this helps!!

Regards

Zsal

[pub10]

 i need to update the firmware . Now I have a version TS201P004. Support said that it is necessary to upgrade to TS230P008, and then to version TS251P006-02 . But where is 230p008 on this website? http://h20564.www2.hp.com/hpsc/swd/public/readIndex?sp4ts.oid=5111379&swLangOid=8&swEnvOid=4064

There's only 251p006-02...

[Jan Soska]

Hello, here is revision history of firmware for P2000g3.

http://h20564.www2.hp.com/hpsc/swd/public/detail?sp4ts.oid=5111380&swItemId=MTX_8253fde8ed454cdf9d477d29df&swEnvOid=4064#tab-history

please check it, the is link to Version:TS230P008 (A) which you need, or you can use this direct link if you need:

http://h20564.www2.hp.com/hpsc/swd/public/detail?swItemId=MTX_21901f95515f48b794947a63f3

Jan