MSA Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

HP Storageworks G3 P2000 Firmware? Issue

 
Sometechy
Occasional Visitor

HP Storageworks G3 P2000 Firmware? Issue

Hello Everyone.

We recently had a power failure and afterwards when our p2000 came back online, one of the controllers seems to have failed. The MAC and IP both show as all 0 and it will not take any settings push to it through ssh. The commands return as successful, but there is no actual change.

We went through one of our supplier for a refurbished controller and slipped it in. It had a higher firmware version and the upgrading of the other one appeared to go well. However the expander controller code version appears to be different between them despite a match. 

The logs are now continuously being spammed every 5 minutes with the error seen in the second picture

( The firmware version is not compatible, HP SPS-CHASSIS 2028)

When I restart the new controller in A, it seems like the data failover is working when I restart controller A. Controller statistics shows new data reading and writing on B when this occurs. 

I'm hoping I can get a little more insight into these behaviors as i'm fairly certain I have exhausted my searching attempts.

Thank you.

 

firmware.PNGwarnings.PNGrearview.PNG

3 REPLIES 3
Torsten.
Acclaimed Contributor

Re: HP Storageworks G3 P2000 Firmware? Issue

Similar problem here

http://h20564.www2.hpe.com/hpsc/doc/public/display?docId=emr_na-c03178496

Reinstall the bundle on this controller (disable PFU, use SMU to update).


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Sometechy
Occasional Visitor

Re: HP Storageworks G3 P2000 Firmware? Issue

Hi, thanks for your response Torsten.

I extracted the bin from the firmware upgrade tool and ran it on the SMU with PFU disabled. It finished with no problems however the Managment controller loader code versions remain the same as they were before. Versions 2028 and 1056. This was again with the TS252P001 bundle. 

Thanks again.

Torsten.
Acclaimed Contributor

Re: HP Storageworks G3 P2000 Firmware? Issue

Is this a single enclosure?

 

However, found this:

http://h20564.www2.hpe.com/hpsc/doc/public/display?docId=emr_na-c02986398

 

maybe you need this

http://h20565.www2.hpe.com/hpsc/swd/public/detail?swItemId=MTX_77c793ab54444148a6f168e42b

or this

http://h20565.www2.hpe.com/hpsc/swd/public/detail?swItemId=MTX_e9bf1c9a4bc04cebadfd6a2a79#tab-history

 


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!