HPE Community
MSA Storage
1752618 Members
4466 Online
108788 Solutions
New Discussion

Re: Incompatible error on San Switch

 
BR826067
New Member

‎08-17-2004 09:13 PM

‎08-17-2004 09:13 PM

Incompatible error on San Switch

I am about implementing CA, but the ISL links seem to have some problems the ports (11) used for the connection has an error (incompatible). So I do not get a link between the 2 SANs, this happens on all four switches. The distance between the source and destination sites is about 6 km and I'm using long wave GBICS.

From the event on the switch, I have the following Message: FABRIC-SEGMENTED port 11, incompatible flow control parameters

Can you help?
0 Kudos
Reply
1 REPLY 1
meloni
Honored Contributor

‎08-18-2004 04:29 AM

‎08-18-2004 04:29 AM

Re: Incompatible error on San Switch

Fabric segmented appear usualy when you have differents config on both unit, you have to clear the configuration and maps on one befor to connect to the other, and configurations will propagate from one to the other
---------------X-------------------X--------------------X----------------X--------------
If everything is under control, you are going too slow (Mario Andretti)
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.