MSA Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

Incompatible error on San Switch

 
BR826067
Occasional Visitor

Incompatible error on San Switch

I am about implementing CA, but the ISL links seem to have some problems the ports (11) used for the connection has an error (incompatible). So I do not get a link between the 2 SANs, this happens on all four switches. The distance between the source and destination sites is about 6 km and I'm using long wave GBICS.

From the event on the switch, I have the following Message: FABRIC-SEGMENTED port 11, incompatible flow control parameters

Can you help?
1 REPLY 1
meloni
Honored Contributor

Re: Incompatible error on San Switch

Fabric segmented appear usualy when you have differents config on both unit, you have to clear the configuration and maps on one befor to connect to the other, and configurations will propagate from one to the other
---------------X-------------------X--------------------X----------------X--------------
If everything is under control, you are going too slow (Mario Andretti)