- Community Home
- >
- Storage
- >
- Entry Storage Systems
- >
- MSA Storage
- >
- Info about MSA1000 / DL380G3-G4 strange behavior
MSA Storage
1753674
Members
5660
Online
108799
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-29-2007 03:26 AM
01-29-2007 03:26 AM
Info about MSA1000 / DL380G3-G4 strange behavior
Hello,
I'm referring to the following thread
http://forums1.itrc.hp.com/service/forums/bizsupport/questionanswer.do?threadId=1060092
this customer asked to me if I can go to loookup this configuration and to discover where is the problem.
I know that there is a "not supported" configuration, but the main question is
Attached the SAN schema
Can anyone answer this question ?
thank you very much
regards Davide
I'm referring to the following thread
http://forums1.itrc.hp.com/service/forums/bizsupport/questionanswer.do?threadId=1060092
this customer asked to me if I can go to loookup this configuration and to discover where is the problem.
I know that there is a "not supported" configuration, but the main question is
Attached the SAN schema
Can anyone answer this question ?
thank you very much
regards Davide
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-29-2007 08:15 AM
01-29-2007 08:15 AM
Re: Info about MSA1000 / DL380G3-G4 strange behavior
You will always see double luns. When you install a Multipath software, the software will mask this infomation from the OS. Perhaps the user didn't set qlogic failover.
jk
jk
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP