MSA P2000 G3 iSCSI PCIE link recovery failed

[AnkitM]

It should work then. Verify if the Volumes are still mapped, if not you can remap it. 

You can also try unmapping and remapping if you are unable to see the shared storage from the host.

If you would need Redundancy then you will need to replace Controller A eventually...sooner the better.

[CrazyDTosser]

Hello everyone!

My MSA still working with one controller without reboots since 23 april. Thanks to all.

[CrazyDTosser]

Too early to celebrate...

MSA is going down. Log in attach. Pls help...

[AnkitM]

It seems Controller B went down:

2015-04-28 11:43:04 [056] #B4085: P2000 G3 iSCSI Array SN#00C0FF128CBA Controller B INFORMATIONAL Storage Controller booted up (cold boot - power up). SC firmware version: T251P08-01
2015-04-28 11:38:40 [107] #B4084: P2000 G3 iSCSI Array SN#00C0FF128CBA Controller B ERROR Critical Error: Fault Type: Gen Prot Fault p1: 0x3FBEDD82, p2: 0x0000000, p3: 0x0000000, p4:

ESXi Hosts are connected to this MSA?! If yes, Can you check if VAAI is enabled or disabled?

[CrazyDTosser]

My MSA connected with two ESXi host version 5.5.

And i disable VAAI now.

[AnkitM · Accepted solution]

Yes, you can disable VAAI by following below VMware KB Article: kb.vmware.com/kb/1033665

[CrazyDTosser]

This is it!  My MSA now work good. Thanks!