- Community Home
- >
- Storage
- >
- Entry Storage Systems
- >
- MSA Storage
- >
- MSA1000 controller
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-05-2012 04:38 AM
11-05-2012 04:38 AM
MSA1000 controller
Hi,
I have inherited a MSA1000 setup configured as follows and since I'm new at this I need your help.
Setup:
* two DL380 G5 with two HBA each.
* two hp storageworks 2/8q Fibre Channel Switches
* one MSA1000 box with two controllers.
Connections:
Server one is connected to each fibre channel switch vi one HBA same goes for the second server. Controller one on MSA1000 is connected to fibre channel switch one and controller two is connected to the second fibre channel switch.
The MSA1000 and Fibre channel switches are not connected to any ethernet network.
Firmware:
MSA1000 is 7.00.
Question:
1. How do I confgiure the HBAs?
2. How do I manage the fibre channel switches? (Switch manager?)
3. As you can see below all traffic is only via one fibre channel switch and Controller. It should go over both??
Redundancy Settings
Redundant Path OK
Redundancy Status OK
Redundancy Mode Active-Active
Controller 1 Serial Number XXXXXXXXXXXXXX
Controller 2 Serial Number XXXXXXXXXXXXXX
Preferred Path Mode Automatic
Controller 1 Preferred Path
Logical Drive 1
Logical Drive 2
Logical Drive 3
Logical Drive 4
Controller 2 Preferred Path
None
- Tags:
- HBA