MSA Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

MSA2000 host port interconnect

 
MartinR01
Occasional Visitor

MSA2000 host port interconnect

Hi,

 

I am very new to fiber channel and SANs.

I recently acquired old hardware for testing purposes.

It includes an MSA2000 (2xMSA2012fc controllers).

I have 2 hosts connecting to each controller as follows:

    host1/port0 -> controllerA/port0

    host1/port1 -> controllerB/port0

    host2/port0 -> controllerA/port1

    host2/port1 -> controllerB/port1

 

The hosts use the HBA HP FC2242SR (Emulex A8003A)

I set up the topology to loop, and setting the host port toStraight-through, I'm able to see the LUNs on my servers.

 

However, as soon as I change the host port to Interconnected, I lose connection on the fiber ports...

The Recieve signal registers as Present, but the Link Status remains as Link Down (on the MSA web page)

 

Is there anyone that could have a clue on what I might be doing wrong?

Any help would be greatly appreciated...

 

Thanks!

1 REPLY 1
Torsten.
Acclaimed Contributor

Re: MSA2000 host port interconnect

loop mode is ok for direct connect, point-to-point is used for switch fabric connections.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!