HPE Community
MSA Storage
1751860 Members
5328 Online
108782 Solutions
New Discussion

MSL4048 discovery

 
Yuriy Bilan
New Member

‎03-05-2007 05:50 PM

‎03-05-2007 05:50 PM

MSL4048 discovery

Hi All.

I am new to the SAN.
I am trying to connect MSL4048FC library to MSA1500 active/active controller. But server (DL380 G3/Windows 2000 Server) does not detect any new equipment. What settings should I check?
Thanks in advance.
0 Kudos
Reply
1 REPLY 1
meloni
Honored Contributor

‎03-06-2007 07:26 PM

‎03-06-2007 07:26 PM

Re: MSL4048 discovery

You need to check the zoning in the switch.
you can check in the switch logs if the unit is logged in

Also the settings in the msl are those related to the FC connectivity, be sure to set them accordly witht the FC port of the switch ( N mode and the correct speed), this setting should be made for each drive, and on the FC port1, the FC port two usualy is not used and should be set in autodetect mode for Fibre Speed and Port Type
---------------X-------------------X--------------------X----------------X--------------
If everything is under control, you are going too slow (Mario Andretti)
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.