- Community Home
- >
- Storage
- >
- Entry Storage Systems
- >
- MSA Storage
- >
- Not operating one of the two controllers hp MSA p2...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-08-2017 10:43 PM
02-08-2017 10:43 PM
Not operating one of the two controllers hp MSA p2000 G3
When planning a power failure in the building, we had to turn off the HP P2000 G3 MSA Array Systems (2 controllers and 2 power supply unit). When the LED on the front panel of the figure 8.
Behind PUF flashes orange. Login to the web interface can not be on one controller. In putty can be connected to any controller, first login, but in the performance of any team, does not give any result. If you pull out a broken controller, the HP MSA P2000 G3 works. Tried to swap flash, replace the batteries in the controller, the controllers were reversed, I tried to run only broken the controller - there is no result. The logs only this error - Supercapacitor failure. Status cell 1voltage is too high (24). Article: failure (12) (p2: 3088 (or 3190,3283,3317,3139,3232), p3: 0).