MSA Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

P2000 G3 SAS Network Port Configuration

 
Highlighted
legionmx
Visitor

P2000 G3 SAS Network Port Configuration

Hi Everyone,

 

I have just installed a P2000 within a clients site, but I've just been informed that due to the company's policy I need to turn off autonegotiation and set the network port to these specific parameters: 100 Full Duplex. The several manuals I have seen so far explain how to change de IP address of the network interface, but none describe if there is a way to set autonegotiation off and set values for that specific interface (the only section that mentions something similar talks about changing the host interface, but ti only applies to the FC and iSCSI ports, not the network ethernet port). Can somebody tell me if this is possible, and how can it be done? Thanks in advance.

2 REPLIES 2
Johan Guldmyr
Honored Contributor

Re: P2000 G3 SAS Network Port Configuration

Hey, I couldn't find any in the CLI manual: http://bizsupport2.austin.hp.com/bc/docs/support/SupportManual/c02520779/c02520779.pdf

Did you look the SMU if it's possible to do it from there?
legionmx
Visitor

Re: P2000 G3 SAS Network Port Configuration

Yes, I looked into both CLI and SMU manual and found nothing.