- Community Home
- >
- Storage
- >
- Entry Storage Systems
- >
- MSA Storage
- >
- P2000G3 Serial Output?
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-03-2013 09:22 AM
10-03-2013 09:22 AM
P2000G3 Serial Output?
Hi everyone,
I've got a P2000G3 FC/iSCSI unit here, and i can connect to its CLI port just fine and run commands and everything looks very nice, but i'm curious if there's another lower level of serial output that is available, perhaps via a different port on the back of the controller.
What I'm looking for is some indication as to when the controllers are booting, syncing firmware, doing other tasks, etc. I'm used to dell or IBM (LSI logic based SANS) output that is very useful for debugging and troubleshooting, as well as knowing exactly when the controllers have finished booting, etc.
Does this exist in HP land?
Thanks!