MSA Storage

Replication Volume error

 
SOLVED
Go to solution
kavandi
Occasional Contributor

Replication Volume error

Hi
 
I have 2 hp msa2040 with firmware version GL210R004 that should be replicated with each other.
these two storages have connected with 4 fiber cable by a san switch.
 
I have 10 Volumes on first msa2040 and there are enough disk-group spaces on second msa2040 without any volume.
when I do Replicate Volume, I select "Create new volume on vdisk" for creating secondary volumes
 
I did replication set on these volumes, some of them replicated correct but some of them made a mistake like bottom photo.
then replication not done but secondary volume and snap pool are created on second msa
the volumes with mistake  are completely similar to correct volumes.
 
could you please help me what should I do?
thanks
 
Replication set error.jpg
5 REPLIES 5

Re: Replication Volume error

@kavandi 

As per the screenshot it seems 10 replication set already created.

Try to initiate replication where you got error. Don't try to re-create replication set again.

If still it's failing then it require in-depth analysis by checking logs. For that you may need to log a HPE case with support.

You need to check space from Source and Destination array both. Please check SMU guide and replication whitepaper or user guide to get guidance on space calculation.

 

Hope this helps!
Regards
Subhajit

I am an HPE employee

If you feel this was helpful please click the KUDOS! thumb below!

*************************************************************************


I work for HPE
Accept or Kudo
kavandi
Occasional Contributor

Re: Replication Volume error

ok. thank you

I will try

EnormousAlien
Occasional Visitor

Re: Replication Volume error


@SUBHAJIT KHANBARMAN_1 wrote:

@kavandi 

As per the screenshot it seems 10 replication set already created.

Try to initiate replication where you got error. Don't try to re-create replication set again.

If still it's failing then it require in-depth analysis by checking logs. For that you may need to log a HPE case with support.

You need to check space from Source and Destination array both. Please check SMU guide and replication whitepaper or user guide to get guidance on space calculation.

 

Hope this helps!
Regards
Subhajit

I am an HPE employee

If you feel this was helpful please click the KUDOS! thumb below!

*************************************************************************


Thank you for posting something like this

Re: Replication Volume error

@kavandi 

Can you please help us to understand if the issue got resolved or not?

If issue got resolved then how? This will help for everyone who are all following your forum.

Also request you to mark the forum as resolved if there is no more outstanding query from your end on this issue.

 

Hope this helps!
Regards
Subhajit

I am an HPE employee

If you feel this was helpful please click the KUDOS! thumb below!

*************************************************************************


I work for HPE
Accept or Kudo
kavandi
Occasional Contributor
Solution

Re: Replication Volume error

Hi

Yes, Fortunately, the problem was solved after a lot of effort

I updated firmware of both MSA 2040s and after that all errors resolved.

thank you