- Community Home
- >
- Storage
- >
- Entry Storage Systems
- >
- MSA Storage
- >
- SAS Mapping MSA 2040 do not appear on VMWare 6.0
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-04-2016 03:39 AM
07-04-2016 03:39 AM
SAS Mapping MSA 2040 do not appear on VMWare 6.0
Hello,
after adding 8 disks to an MSA 2040 storage, and configured the mapping the new volumes do not appear on VMWare to create the datastores.
The storage is connected to vmware hosts via SAS cables.
Controller A from storage to each hba from the 2 hosts.
I already have 2 disk groups presented to the 2 vmware hosts, from initial config.
This is an upgrade of disks, and i think the config from storage is correct so I'm not understanding why the targets aren't showing up.
Is any way that I can view logs of the scan of new maps?
Can anybody help me?
Rui R.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-08-2016 01:46 AM
07-08-2016 01:46 AM
Re: SAS Mapping MSA 2040 do not appear on VMWare 6.0
Hi,
As per HPE SPOCK, VMWare 6.0 is supported in direct connect mode with MSA 2040.
Is this is a new installation, were any volumes from the MSA already presented to the VMware host ?
Also as per SPOCK
"HP MSA 2040 SAS controller requires a mini-SAS HD connector for host connections. Validate your HBA or Switch connector to purchase the correct cable separately."
What message does the VMWare Storage rescan indicate ? Does it throw any errors ?
Best Regards,
Raj