- Community Home
- >
- Storage
- >
- Entry Storage Systems
- >
- MSA Storage
- >
- can not set "Switch PID Format" to 0
MSA Storage
1753265
Members
5300
Online
108792
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Go to solution
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-30-2009 03:43 AM
07-30-2009 03:43 AM
I have to set the PID format to 0 because the switch replaces one with that setting.
Switch PID Format: (1..2) 0
integer must be between 1 and 2 - please re-enter
Firmware: V5.3.2.
Is there a way to use this switch whiteout altering the HW_path in hp-ux?
Switch PID Format: (1..2) 0
integer must be between 1 and 2 - please re-enter
Firmware: V5.3.2.
Is there a way to use this switch whiteout altering the HW_path in hp-ux?
Solved! Go to Solution.
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-30-2009 05:20 PM
07-30-2009 05:20 PM
Solution
If the new switch you have has more than 16 ports, PIDformat must be < 0.
I also vaguely recall v5.x firmware enforces PIDformat of < 0 to ensure support for switches with < 16 ports in the fabric.
Is you old switch a 1 or 2Gb switch with <= 16 ports? It was the default setting for old switch/firmware combinations but changed I think with v5.
I also vaguely recall v5.x firmware enforces PIDformat of < 0 to ensure support for switches with < 16 ports in the fabric.
Is you old switch a 1 or 2Gb switch with <= 16 ports? It was the default setting for old switch/firmware combinations but changed I think with v5.
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP