MSA Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

change MSA 2312fc Loop to PTP

 
SOLVED
Go to solution
hodhod26
Occasional Contributor

change MSA 2312fc Loop to PTP

HI All,

 

i need to change MSA 2312fc from loop to Point To point. is ther any help ?

 

Regards.

4 REPLIES 4
Torsten.
Acclaimed Contributor

Re: change MSA 2312fc Loop to PTP

Select the rear view in web gui and click on the fc ports - then you get the settings, afair.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Jason_L
Valued Contributor
Solution

Re: change MSA 2312fc Loop to PTP

You can also use the CLI using "putty" or similar:

 

Syntax:  set host-parameters controller both ports all fibre-connection-mode point-to-point

 

Options:

[controller a|b|both]

[speed 1g|2g|4g|auto]

[ports #|all]

[fibre-connection-mode loop|point-to-point]

[ip address]

[netmask address]

[gateway address]

[prompt yes|no|y|n|expert]

[noprompt]

[fibre-loop-id values]

 

I assume these are connected to FC switches and all zoning needed has been configured?

 

 

I work for HPE.
hodhod26
Occasional Contributor

Re: change MSA 2312fc Loop to PTP

thanks it working.
Jason_L
Valued Contributor

Re: change MSA 2312fc Loop to PTP

Good deal, thanks for the follow-up! :)

I work for HPE.