Simpler Navigation for Servers and Operating Systems - Please Update Your Bookmarks
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
If you have bookmarked forums or discussion boards in Servers and Operating Systems, we suggest you check and update them as needed.
Showing results for 
Search instead for 
Did you mean: 

HP Netserver LH Pro

Occasional Visitor

HP Netserver LH Pro

I had an ATA hard drive in my SCSI system. The drive went out and now it "Cannot find the Operating System". It will not alow me to push f12 to get into the setup to remove the drive 1 refference to "None or SCSI". The switches on the mother board say's I can switch #3 to off and reset the BIOS. Right I'm a little nervious to try this. Would this fix my problem? How do I bypass the startup in order to change the BIOS?
Bryan Eley
Trusted Contributor

Re: HP Netserver LH Pro

The LH Pro is an EISA unit, so it will need an ECU (Eisa Configuration Utility) to access the BIOS. You can find the ECU for the LH Pro here

If the ECU asks for !HWP2090.CFG, you may need to download the LM ECU from here to obtain that file:

You should then be able to change the proper settings and alter the drive settings.