- Community Home
- >
- Servers and Operating Systems
- >
- Legacy
- >
- Netservers
- >
- NETSERVER LH II PROBLEMS
Netservers
1753546
Members
5437
Online
108795
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-19-2006 12:30 PM
11-19-2006 12:30 PM
NETSERVER LH II PROBLEMS
I buy an old LHII without Hard Drive, and buy 3 hard disk SCSI of 9 gb 10000 rpm hotswap, i download a ECU soft. Ok the question is: how install NT4 o Linux? how i create a boot sector? The LHII have an embedded SCSI controller (AIC-7880). I put in the upper cage 1 disk, and the lower cage two disk. Thank very much.
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-21-2006 02:50 AM
11-21-2006 02:50 AM
Re: NETSERVER LH II PROBLEMS
First you need to verify what controller the hotswap cages are attached to. These older units did not come with RAID controllers if that is what you are excepting, and only have an Adaptec SCSI controller onboard. Any RAID controller would added as a PCI card.
If a RAID controller exists, you will need to create a Logical Drive from the 3 physical installed drives using the RAID BIOS (). The drives will not be available to the OS until a logical drive is created on the RAID controller.
Either way you will probably have to load drivers for either the SCSI card or RAID card when prompted during the NT4 install (F8) to get the drives available to the install.
If a RAID controller exists, you will need to create a Logical Drive from the 3 physical installed drives using the RAID BIOS (
Either way you will probably have to load drivers for either the SCSI card or RAID card when prompted during the NT4 install (F8) to get the drives available to the install.
Hot Swap Hard Drives
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP