HPE Community
Netservers
1752283 Members
4644 Online
108786 Solutions
New Discussion

Netserver LC2000 and E800 wont boot

 
Jeppis
Occasional Contributor

‎10-09-2007 12:54 AM

‎10-09-2007 12:54 AM

Netserver LC2000 and E800 wont boot

Hi
Have 2 servers LC2000 and E800 that wont boot. They have been offline for a couple of months and now neither of them will boot. They start up without any error beeps, harddisks are running, but no info to the monitor. When they were online both worked nicely. What could have happened? Any solutions? Tried with a new graphic card with no luck
0 Kudos
1 REPLY 1
e4services
Honored Contributor

‎10-10-2007 02:03 AM

‎10-10-2007 02:03 AM

Re: Netserver LC2000 and E800 wont boot

When this happens, the system is failing the POST. This can be for a lot of reason. You can verify a systemboard problem by removing CPU, Memory and all cards, then try powering on to see if you get beep codes for no cpu, memory, if you are lucky it is one of those. If no beep code still, then something in the systemboard has failed and it would have to be replaced.
Hot Swap Hard Drives
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.