BladeSystem Forums have moved here
To make BladeSystem information easier to find, we have moved the BladeSystem forums here, to Servers and Operating Systems.
Netservers
Showing results for 
Search instead for 
Do you mean 

New processor in LC2000 and some other q

Occasional Visitor

New processor in LC2000 and some other q

I buy in this week an old HP LC2000 600Mhz with 2g ram, 6x18gb hdd.

And have some questions:

1. The power supply led blink at red, is it posible that the power supply i broken.

2. Now i have there a 600/256/133/1.65V processor can i put there a 1000/256/133/1.7V on the same VRM ?

3. The fan led blink red but i think its becouse the one fan is not working i must replace fan.

4. I made a raid 5. And when is one hdd broken how server show witch one ??

I'm from poland, and my english isn't so good.
1 REPLY
Highlighted
Honored Contributor

Re: New processor in LC2000 and some other q

The Manual:
http://bizsupport1.austin.hp.com/bc/docs/support/SupportManual/lpn10745/lpn10745.pdf

"RPS (Redundant Power Supply) LED has three
distinctive colors:
l steady Green for normal operation
l blinking Red at 1 Hz blink rate for a bad power
supply
l blinking Amber at 0.5 Hz blink rate for a
warning condition indicating a power supply
may not be working correctly."

2. Yes, VRMs are universal

3. The Manual:
"This Fan LED has three distinctive colors:
l steady Green for normal operation
l blinking Red at 1 Hz blink rate for a nonoperational
fan condition inside the NetServer
l blinking Amber at 0.5 Hz blink rate for a
warning condition indicating one of the fans
may be turning too slowly."

4. Status LED Activity Status LED
Off: Disk not present, or not
connected to the cage
Off: No disk activity
Green (solid): Disk present Green (flashing): Accessing disk
Green (solid for more than one
minute): Disk spinning up, or "hung"
Amber (flashing): Disk failure
predicted
Red (flashing): Disk failed
Red (solid): No +12 volt power
Hot Swap Hard Drives