netraid card

[Cliff_25]

Can I run my Lh pro II netserver with out the Netarray Card?


AND hOW CAN i DO IT?

[Andrew Rutter]

hi,

yes you can, just disconnect the scsi cable and connect it to one of the onboard scsi connectors on the system board.
There is a cabling diagram on the side of right hand side near the disks when you move the outer case.

You will see the disks then as jbod though, and will have to reconfigure/install onto them


Andy

[Cliff_25]

THANKS Andrew

I connected the cables but how do I config without the netraid card.

[Andrew Rutter]

hi,

boot your operating system cd/floppy and you should see the discs and then you can install onto one of them.
If its NT then you may need to patch the drivers in for the scsi controller, during install. These can be downloaded from hp's website or from the navigator cd.

Alternatively you can just run through the installation wizard from the navigator cd.



Andy