- Community Home
- >
- Servers and Operating Systems
- >
- Legacy
- >
- Netservers
- >
- tc4100 With NetRaid adapter - Define 2nd logical d...
Netservers
1752726
Members
5624
Online
108789
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-19-2006 08:16 AM
10-19-2006 08:16 AM
tc4100 With NetRaid adapter - Define 2nd logical disk in SCO UNIX
We are upgrading a TC4100 HP server from SCO openserver 5.04 to openserver 5.07. There are 4 physical disks attached to the net raid adapter that are mirrored pairs, creating 2 logical drives. I am able to load the 5.07 onto the first logical drive, but cannot get Unix to recognize the 2 logical drive. When I attempt to define the 2nd logical drive (by using LUN 1), it finds the first logical drive. The 1st logical drive is defined as ha=0, id=0, lun=0, bus=1, I try to defined the 2nd logical drive as ha=0, id=0, lun=1, bus=1 but this ends up pointing back to the first logical drive. Am I addressing the logical drive incorrectly?
- Tags:
- RAID
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-03-2006 01:32 AM
11-03-2006 01:32 AM
Re: tc4100 With NetRaid adapter - Define 2nd logical disk in SCO UNIX
SCO doc showed to set the LUN to the next number (logical disk 1 = lun0, ld2 lun1, etc.). Finally located doc on the amird driver stating that the target ID should be increased for each logical disk (ld1 = target id 0, ld2 = target id 1, etc.). This resovled the issue. SCO open server 5.07.
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP