- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Network Simulator
- >
- HP EVI SUpport on the HP Simulator
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-20-2015 01:10 AM
10-20-2015 01:10 AM
HP EVI SUpport on the HP Simulator
Dear,
I am trying to run EVI on the simulator but not working
The evi enable command bring error that Operation is not supported.
Also when i change link to serial, the command is not supported at all, so accpeted only on gigethernet but bring that error.
[HQ-R1]int GE0/1
[HQ-R1-GigabitEthernet0/1]ev
[HQ-R1-GigabitEthernet0/1]evi en
[HQ-R1-GigabitEthernet0/1]evi enable
The operation is not supported.
[HQ-R1-GigabitEthernet0/1]
May you advise ?
Regards,
Wael Agina
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-10-2015 02:57 PM
11-10-2015 02:57 PM
Re: HP EVI SUpport on the HP Simulator
I'm not sure EVI is configurable in the simulator. Even if you could traffic will probably not pass, because the simulator does not support ASIC specific encapsulation. The same counts for example for SPB.
A better way is to use the Virtual Services Router (VSR). The latest code supports EVI and you can get a 60-day demo license.
You can download it form the mynetworking portal under the software section:
http://www.hpe.com/networking/mynetworking