HPE Community
Networking
1753518 Members
5095 Online
108795 Solutions
New Discussion

Vista and Procurve 4104gl

 
Larry Marcus
New Member

‎03-20-2007 03:06 AM

‎03-20-2007 03:06 AM

Vista and Procurve 4104gl

I'm grasping at straws here so please forgive me if this sounds stupid. At the college here we have a Vista Laptop that connects to our network from the IT offices, but cannot in the RezHall. In the Rezhall it goes to a Procurve 4104gl. It will pull an IP but I cannot ping the gateway (the 4104). I receive a Destination unreachable. I have turned off IPv6 and the tunneling stuff that comes built in with Vista. Is it possible there is something with the switch and Vista that might be causing this?? Again, grasping at straws here.
0 Kudos
1 REPLY 1
Jon Finley
Honored Contributor

‎03-20-2007 08:47 AM

‎03-20-2007 08:47 AM

Re: Vista and Procurve 4104gl

If you're using Cisco Clean Access in the Res Halls, it's currently NOT compatible with Vista.

There is an update and upgrade path involved.

"Note: Vista is not supported on CCA 4.1(0)/4.1.0.1/4.1.0.2."

Only in version 4.0.4.0+

Jon
"Do or do not. There is no try!" - Yoda
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.