Simpler Navigation for Servers and Operating Systems
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
Operating System - Microsoft
cancel
Showing results for 
Search instead for 
Did you mean: 

Question about HP4 printers

Mike Terryberry_1
Occasional Visitor

Question about HP4 printers

Is there any way to prevent the HP4M printer (with HP JetDirect card) from
propogating IPX traffic on a network?

We are using JetAdmin v2.53 and it only gives you two options for protocol
traffic behaviour - Novell (IPX/SPX) and All. Is there perhaps an updated
JetAdmin program that allows you the option of including/excluding individual
protocols?

- Mike
1 REPLY
Gerard Laygui
Frequent Advisor

Re: Question about HP4 printers

Mike,

You may need to flash the firmware on your JetDirect card. Doing this enables
the JetDirect card to use more than IPX/SPX. Other protocols available are
TCP/IP and DLC. On some models AppleTalk is also available. The firmware
upgrade is a must if you want the JetDirect card to do more. Advice for doing
this upgrade:

1. Do this on the same network segment. Make sure you are not going across a
router else this simple firmware flash will become very difficult.

2. Do this when there is not too much network traffic.

Hope this helps you out,

---Gerard