HPE Community
Operating System - OpenVMS
1752785 Members
6135 Online
108789 Solutions
New Discussion юеВ

Re: Autogen on Alpha 8400

 
SOLVED
Go to solution
Dale A. Marcy
Trusted Contributor

тАО01-11-2005 06:28 AM

тАО01-11-2005 06:28 AM

Re: Autogen on Alpha 8400

You need to make sure it was not needed. You might be in for a surprise the next time you reboot your system. The SYCONFIG also gets executed during system startup and that might be where you need the mount commands. Read Uwe's reply about checking if the disk is previously mounted before mounting it.
0 Kudos
LM_2
Frequent Advisor

тАО01-11-2005 06:40 AM

тАО01-11-2005 06:40 AM

Re: Autogen on Alpha 8400

I did check and the part it was erroring out on was no longer needed. The system has been rebooted since and everything is good. Thanks for everyones help!!
0 Kudos
LM_2
Frequent Advisor

тАО01-11-2005 06:43 AM

тАО01-11-2005 06:43 AM

Re: Autogen on Alpha 8400

See previous replies from me.
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.