HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Community
Operating System - OpenVMS
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Change the floating IP address & fixed IP addresses for both HP Unix nodes running in cluster conf

 
skwchan
skwchan
Occasional Contributor

‎03-12-2007 11:09 PM

‎03-12-2007 11:09 PM

Change the floating IP address & fixed IP addresses for both HP Unix nodes running in cluster conf

Hi Everyone

I have two HP 9000 nodes configured to run in a MC/SG cluster. I need to do a total reconfiguration as below:

1) change the existing fixed IP addresses for both nodes from 127.31.100.1 & 127.31.100.2 to 127.50.100.1 & 127.50.100.2 respectively.

2) change the floating IP address inside the package "smsc6_lan" from 127.31.100.10 to 127.50.100.10

I am not sure how to do that.

Any idea for me to finish it during a short maintenance down time.

Thanks in advance very much...
0 Kudos
Reply
1 REPLY
Karl Rohwedder
Karl Rohwedder
Honored Contributor

‎03-12-2007 11:20 PM

‎03-12-2007 11:20 PM

Re: Change the floating IP address & fixed IP addresses for both HP Unix nodes running in cluster conf

The best idea would be to ask this question in the proper forum :-)
This is the OpenVMS forum covering OpenVMS...

regards Kalle
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.