Operating System - OpenVMS
cancel
Showing results for 
Search instead for 
Did you mean: 

Dialin access to decserver 900

 
SOLVED
Go to solution
Carl Merrick
Occasional Advisor

Dialin access to decserver 900

We have a decserver 900TM that we would like to use for dial in access for Windows workstations. It is currently being used for terminal dial in access for OpenVMS (7.2). Once the windows workstation is connected we would like the user to be able to access Windows Terminal Servers over RDP. Is this even possible? How does the Decserver need to be configured? What is required on the workstation side? If it can be done, could someone point me to the documentation necessary to configure this.

Thanks, Carl
7 REPLIES 7
Vladimir Fabecic
Honored Contributor
Solution

Re: Dialin access to decserver 900

Yes, it is possible. You need software 2.2 or above for ppp to work fine. A long time ago we used decserver 900TM for dialup connections. You need to configure terminal server for that, which is a little bit complicated. I will try to find manual for this if you need it.
In vino veritas, in VMS cluster
Vladimir Fabecic
Honored Contributor

Re: Dialin access to decserver 900

Try this:
DEF PORT x PPP ENABLE
DEF PORT x PPP LCP ACFL ENABLE
DEF PORT x PPP IPCP ADDRESS ENABLE
DEF PORT x PPP IPCP COMPRES ENABLE
DEF PORT x PPP IPCP HOST
When connected to network you can access any host and any service.
Do not forget to check modem setup and port setup (flow control, DSR status and so on).
Workstation can use normal dial-up connection like connection to internet.
This (http://www.dnpg.com/dr/dnas/2.4/documentation/IG-DNAS0-00.pdf)
is not the manual I have had but I will try to find it.
In vino veritas, in VMS cluster
Vladimir Fabecic
Honored Contributor

Re: Dialin access to decserver 900

Hello!
I have found the manuals. You can download them from my ftp server. Location is "ftp://csalf.cs.hr/DNAS/". Do not use web browser for downloading because it will not see them. Use command prompt. I hope it will help you.
In vino veritas, in VMS cluster
Ian Miller.
Honored Contributor

Re: Dialin access to decserver 900

Carl, Welcome to the VMS forum - I see you have not yet assigned any points to replies (to thank the people who have helped you).
See
http://forums1.itrc.hp.com/service/forums/helptips.do?#33

Then you can use the following link to find the reponses.

http://forums1.itrc.hp.com/service/forums/pageList.do?userId=CA1254329&listType=unassigned&forumId=1
____________________
Purely Personal Opinion
Jan van den Ende
Honored Contributor

Re: Dialin access to decserver 900

... and let me add a big

WELCOME

for Vladimir as well!

Proost.

Have one on me.

Jan
Don't rust yours pelled jacker to fine doll missed aches.
Carl Merrick
Occasional Advisor

Re: Dialin access to decserver 900

Vladimir, Thanks for the reply. I was able to come up with the DNAS software from our archives and found the approriate manual online at http://www.dnpg.com/tech_doc_dnas.asp

Carl
BobRich
Occasional Visitor

Re: Dialin access to decserver 900

Hello;

We just removed our Decserver 900tm from service. Does anyone need it? Let me now, thanks Bob