ENABLE RMC

[KARTHIK_12]

Dear all,

Till now we have not used RMC console in our environment.now we have tried to enable the rmc.

actualy all es40 & es45 servers having three ports.one is MMJ port,which port is using for serial console.another one is COM2,which is not used. third one is COM1,which port is tried to connect terminal to enable RMC.
But we couldn't done.

I gave the ^[^[rmc key,but no response in the terminal.any jumper settings need to enable on the servers motherboard?.

or

any basic steps need to be done.


Thank you
Kk

[marsh_1]

hi,

you can get to the rmc on your serial console mmj , if ^[^[rmc does not work try ^[^[rcm.

hth

[Benjamin Levy]

Hello

ES40 backplane jumper J31 has 3 alternatives:
- pin-1 connected to pin-2
- pin-2 connected to pin-3
- jumper not installed at all

We have all our ES40's configured with alternative #3 - no jumper at all, and then use the following port mapping:

ES40, with jumper J31 removed
MMJ = RMC
OPA0 = lower DB9
TTA0 = Upper DB9
this has worked well for us.

In the default jumper configuration, one port multi-tasks between OPA0 and RMC.

Hope this helps!

[Hoff]

ITRC dropped the first posting attempt; this is a re-post. Apologies on any duplicates that might appear.

For how to connect (via the COM1 port) and how to use and manage the RMC, please read the technical manuals for the boxes.

The AlphaServer ES40 manual is here:

http://h18000.www1.hp.com/alphaserver/archive/es40/es40_tech.html

In the above, the RMC is chapter 6, and the jumper is page 6-26.

Here's the AlphaServer ES45 box:

http://h18000.www1.hp.com/alphaserver/es45/es45_tech.html

Here's the previous thread on this topic:

http://forums11.itrc.hp.com/service/forums/questionanswer.do?threadId=1335210

Here's a general write-up on the RMC for one of these boxes.

http://labs.hoffmanlabs.com/node/445

As an alternative toward advancing your career and your skills, consider calling in some (more) experienced help here or talk to your manager about obtaining some guidance and for access to whatever training might be available here; you're quite clearly not getting the detailed level of assistance that seems needed here in ITRC.

And I strongly discourage altering any of the RMC thermal protection settings -- outside of a life-critical override or similar environment, that is.

[KARTHIK_12]

Dear friends...

Thanks for all..

Mr.Benjamin,with out change jumper settings,can i do enable the RMC.

In our site MMJ(com1) is connected as a console terimal.com2(DB9) and modem port(DB9) is not used.

We want to use both cosle(RMC,SRM(OPA0)).If i used MMJ(com1) as a RMC console.how can i use SRM?.


Thank you
K.karthik

[marsh_1]

hi,

just quit out of rmc and it'll return you to srm.